CASTLE EURO Installationshandbuch PDF herunterladen (Seite 57)

Programming Manual EURO

RINS1291-3 Page: 57

4.23.2 Programming Contact iD, SIA, SMS, WebWayOne and Chiron

The Contact iD, SIA and SMS signalling protocol can also be used. However the programming

differs from Fast Format, here you have to select the content types you would like to be sent

to the Alarm Receiving Centre. The table below shows the types you may have.

Content Types

1 Set: System Set, Secure set system, System rearm, System Final Set,

2 Unset: System Unset, System unset by Autoset, Autoset cancelled by a user, Forced Set, set

by Autoset

3 Special Unset: Special Unset, Access Exit Requested

4 Set Fail: Set Failure, Set Failure with input

5 Alarms: Case/SAB Tamper, Power Fault, Fire Input Active, Day Alarm Input Active, Intruder

Input Active, Radio Low Battery, Fire Key Pressed, Burglary Alarm, Gas Alarm, Tamper Alarm,

CCTV, Tamper on Input, Entry/Exit Alarm, No Input Activity Sent, Day Alarm, Perimeter,

Interior Alarm

6 First Alarm: Burglary Alarm Once, Gas Alarm Once, Tamper Alarm Once, Entry/Exit Alarm

Once, Day Alarm Once, Interior Alarm Once,

7 Alarm Silenced

8 Confirmed: Confirmed Signal

9 Lo Tech Faults: STU Telecom Line OK, CCTV Line Fail, CCTV Line OK, Telecom Line OK,

10 High Tech Faults: Any faults from Mains, Battery, Communications, Fuses, Device

Fail/Restored, Digi Fail Comms, STU Comms Failure, Detector Fault, Detector Masked, Telecom

Line Fault,

11 System Changes/Resets: Clock Set From/To, Added/Deleted/Changed Code, System Restart,

Twin Device, Excess Current, Logs Cleared, Engineer Reset, Clean Start, Site Changed, CHC Call

Failed, Logs nearly full, PC Clock Set to,

12 Manager Info: Unset System

13 Engineer Info: Engineer Access/Exit

14 Access Control Alarm: Door Left Open/Forced

15 Access Control Info: Tag at Reader

16 Access Control Ref: Invalid Tag

17 Special Log Switcher On: Input Special Log Switcher Open

18 Special Log Switcher Off: Input Special Log Switcher Closed

19 Special Log Other On: Input Special Log Open

20 Special Log Other Off: Input Special Log Close

21 Shunt/Ward Set: Shunt Opened Ward Set

22 Shunt/Ward Unset: Shunt Closed Ward Unset/Silenced

23 Shunt/Ward Alarm: Ward Alarm

24 Walk Test: Input Walk Tested

25 Restores: Burglary Restore, Gas Restore, Tamper Restore, Entry/Exit Restore, Tamper on

Input Restore, 2 Key PA Restore, iD line short restore, Fuse fail restore, Case Tamper Restore,

SAB Tamper Restore, Day Alarm Restore, Interior Alarm Restore, Radio Low Battery Restore,

Radio Jamming Restore, Radio Supervision Restore

26 Not Used

27 Mains Fail: Mains Fail Alarm/Restore

28 Duress: Fire Alarm, PA Alarm, HoldUp Alarm, Duress Code, Fire Alarm Once, PA Alarm Once,

Holdup Alarm Once, Fire Restore, PA Restore, Hold Up Restore,

29 Emergency: Emergency Input Opened, Emergency Alarm Once, Emergency Restore,

30 Input Status: Input Omitted, Input Force Armed

31 Aborts: Stopped Set, Abort

4.23.3 PABX Systems (Only relevant to SMS)

Please note for PABX telephone systems (where a “9” is needed in order to dial an outside

line), you must put “NN” before the account number in the “account reference” part of the

programming (see below). If you haven’t been given an account number then the account

reference “NN1111” would be OK to use. This needs to be entered on the keypad.

*Not available on the EURO 28

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

CASTLE EURO Installationshandbuch Seite 57

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme CASTLE EURO