CASTLE EURO Installationshandbuch PDF herunterladen (Seite 18)

EURO Programming Manual

Page: 18 RINS1291-3

Input Area

Enter the areas/level sets you would like the

input to operate in (To select level setting

instead of areas please refer to Site Options

“Use Level Set”, see page: 42). NOTE: The

primary Areas are A, B, C and D. Press the

key.

(This shows the display of a EURO 76 panel)

For area setting systems only:

Enter : for Any Enter : for All

Press the key

Input Attributes

Press the  key to select any attributes for

the input (for details on each attribute see

page: 16)

Chime

Enter : for No. Enter : for Single.

Enter : for Follow. Press the  key

Omittable

Enter : for No. Enter : for Yes.

Press the  key. Repeat for Double Knock,

Dual Trip, Normally Open, Monitor Activity*,

Until special log:

Special Log*

Enter : for No. Enter : for Set.

Enter : for Unset. Enter : for

Always. Press the  key. Paired Input will

be displayed, leave this setting and press the

 key.

Paired Input (With iD Plus Biscuits G3)

When using two biscuits on a detector, set

this to yes. Press the  key.

Fault Input will be displayed. If you are

programming biscuit 2, the biscuit connected

to the mask/fault terminals of the detector,

set this to ‘yes’ otherwise, leave at ‘no’.

Press the  key. ‘Paired with’ will be

displayed. Enter the input number of the

biscuit you are pairing with (for each biscuit

of the pair), e.g. if programming biscuit 2,

enter the input number of biscuit 1. Press the

 key.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare