CASTLE EURO Installationshandbuch PDF herunterladen (Seite 35)

Programming Manual EURO

RINS1291-3 Page: 35

4.15 Change Outputs

Any output type may be programmed to any of the systems outputs. Outputs must be used

within their rated capacity. Please see the installation manual.

NOTE: Only the ATE outputs can be inverted.

4.15.1 Output Types

Type Active Restore

0000 Not Used (permanently off)

0001 Fire At alarm

When a valid code is

entered

0002 Hold Up Any

At a HU or Duress alarm

(This includes keypad HU)

When a valid code is

entered

0003 Intruder Any

At alarm, while system is

disarmed

At first valid code entry

and at end of confirm time.

0004 Final Set All* When system is FULLY armed At code entry to unset

0005

Misoperation Any

(Abort)

When system is silenced after

any ‘intruder’ output is

triggered

After 2 minutes

0006 Confirmed Any

When further input active in

any area after ‘intruder’

alarm

At next code entry

0007 Tamper Any Any tamper alarm

At code entry to silence

And at end of confirm time.

0008 Duress

At a Duress alarm (i.e. from a

keypad)

When a valid code is

entered

0009 HU Device Any At alarm on a HU input only

When a valid code is

entered

0010 Gas* At alarm

When a valid code is

entered

0011 Set Fail

Pre-set time after start of exit

time, if exit procedure is not

complete

At code entry to rearm

0012 Entry Deviation

When deviation from entry

route occurs, during entry

time

At code entry to unset

0013 Secure Intruder Any

At alarm, after exit time

started, until unset

At first valid code entry

and at end of confirm time.

0014 Siren Any When alarm live

When alarm silenced or

when siren timer expires

0016 Strobe Any When alarm live

When alarm silenced or

when strobe timer expires

0017 Omit Rearm Any

Input omitted if active (or in

alarm condition) at the end of

confirmation time.

When system disarmed

0018 Unconfirmed Any Any intruder or Tamper alarm At code entry to silence

0019 Can Set All*

If all inputs and technical

faults in system are clear.

Also once entry time has

started

If fault exists, and after

final set

0020 Exit Starts All*

At start of exit time to set

LAST area

At code entry to unset

FIRST area (i.e. no longer

fully set)

0021 Exit Starts Any

When exit time starts to set At code entry to unset

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

CASTLE EURO Installationshandbuch Seite 35

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme CASTLE EURO