CASTLE EURO Installationshandbuch PDF herunterladen (Seite 36)

EURO Programming Manual

Page: 36 RINS1291-3

Type Active Restore

FIRST area LAST area

0022 Final Set Any When FIRST area is set

At code entry to unset

LAST area

0023 Strobe Set Fail

Works similar to output 016, but also fires if the set fail

timer expires.

0025 Keyswitch unset

This output turns on for 5 seconds when the system is

disarmed via a keyswitch input (either pulsed or latched

keyswitch)

0026 Set with Omit Activates when inputs are omitted on setting

0031 Entry* Live during any exit time

0032 Exit* Live during any entry time

0033 Entry/Exit Live during any entry or exit time

0034 Lights

When exit or entry timer

starts

20 seconds after set/unset

procedure completed

0035

Follow Input*

See page: 39.

When input triggers

Dependant upon

programming

0036 Shunt Fault* See Shunt Inputs - Page: 19

0037

Reset 1 (Viper

Reset)

At code entry to set After 3 seconds

At code entry to set When unset

0038

Reset 2 (Viper

Set/Unset)

Re-triggers whenever an additional area is set

0039 PIR Latch 1 When set (and in Walk Test) At alarm, or when unset

0040 PIR Latch 2 This is the inverse polarity to PIR Latch 1

0041 Mains Good Output showing the mains is healthy

0042 Detr Indn Enable*

This output activates during walk test and also when a

code is entered to view indications – staying activated for

the time for which the indications are viewed.

0043 Follow Test New output for alternative bell test by activating SAB

0044 Off During Test New output for alternative bell test by activating SAB

0048 Detr Walk Test

This output is active during walk test, and will only

deactivate when all detectors have been tested.

0051 Line Fault

When Line Fault signalled by

communicator

When fault clears

0052 Mains Fail

After pre-set time without

mains power

On restoration of mains

0053 Battery Faults

When battery disconnected or

load fail detected

At next valid code entry

0054 Low Volts At fault When fault clears

0055

Global Fault 1

(Faults: Modem,

Battery, Fuse, Line,

Mains)

Activates if fault occurs only

when system is armed

When all faults cleared

0056

Global Fault 2

(Faults: Modem,

Battery, Fuse, Line,

Mains)

Activates if fault occurs at

any time

When all faults cleared

0057 German Relay* DO NOT USE

0058 Guard Code Used When ‘guard’ code accepted After 60 seconds

0059 Engineer Access When entering Engineer Mode

When leaving Engineer

Mode

0060 Initialise Digi At power up Live for 45 seconds only

0063 Test ATE/GSM*

Test signalling through PSTN

and GSM. Activates when a

When test completed

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

CASTLE EURO Installationshandbuch Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme CASTLE EURO