CASTLE EURO Installationshandbuch PDF herunterladen (Seite 32)

EURO Programming Manual

Page: 32 RINS1291-3

4.13 Volume Control

The Volume Control function applies to the loudspeaker output only. Volume levels at the

keypad are programmed individually – please see page: 8.

4.13.1 Code Stops Sound

If this function is enabled, then once an alarm has been generated (even if the code is not

programmed for that area) the alarm will be silenced, and a ‘Misoperation (Abort) signal’ will

be sent, but the area will still be set until a valid user that controls that Area is entered.

The default is Yes. If disabled, the codes will only work for the programmed area.

4.13.2 E / E Keypads Only

If there is a speaker connected to the SPK output of the EURO system the entry and exit tones

will be heard through the speaker. If you would like Entry and Exit tones to be heard on only

the keypad and not the speaker then enable this function. The default is selected as No.

4.13.3 Alert Kps Only

If this function is enabled then any Alert tones will be heard on the Keypad only and not the

speaker. The default is selected as Yes.

Note: 0=Completely Silent, 1=Silent,but sounds a beep when the system is set

The default volume settings are as follows:

Entry: 4 Tamper 6

Exit 4 Day Alarm 6

Alarm 7 Chime 3

Fire 7 Intelligent Set 3

Volume Control

Using the and keys, scroll to

‘VOLUME CONTROL?’

Press the key

Area Volume

Use the numeric keys select the volume level

required for Entry and Exit tones for each

Area, once selected, press the key.

Repeat for Alarm, Fire, Tamper, Unset,

Chime and Intelligent Set tones. Press 

Code Stops Sound

Enter : for No Enter : for Yes

Press the key. Repeat for E/E Keypads

Only and Alert Keypads Only. Press the

key. You will be returned to the Engineer

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 67 68

Keine Kommentare

CASTLE EURO Installationshandbuch Seite 32