CASTLE Meridian Spezifikationen PDF herunterladen (Seite 13)

Started Manual Castle Care-Tech Ltd

4·00 Page

25

11. PROGRAMMING THE SYSTEM

CLEAN START

It is essential that a ‘clean start’

be performed at initial power up

of a new system, to ensure that

the initialisation is correct to

true factory defaults.

If the Non-Volatile Memory (NVM)

chip is ever removed from the

End Station, it MUST be replaced

before starting programming.

To perform a ‘clean start’:

With the display showing

CLEAN START?

Press YES

Clean Start?

[ ]

Enter

2000

Clean Start?

Please Wait

Panel has been

clean started!

Press YES

Clear Codes?

If you wish to keep the

existing codes on the

system press NO,

otherwise press ‘Yes’

Initialise Logs?

Press ‘Yes’ to clear logs

The system memory will now be

restored to factory defaults,

EXCEPT:

Keypad 00 remains enabled

at all times

Keypad in use remains

enabled.

Current Keypad areas are

NOT changed

Note: If a new NVM chip is to be

used, Logs must be cleared (see

page 49)

INHIBIT FIRE/HU?

It is possible to prevent the panel

from alarming from fire or Hold

Up zones whilst in engineering

menu through this option. Please

be aware of the potential liability

and hazard of inhibiting these

zone types.

INHIBIT FIRE/HU?

When you come out of

engineering, the inhibited zones

will be re-instated automatically.

SOFTWARE REVISION

Selecting this option will display

the software version fitted to

the system, eg

Rev 5.00 UK

12345678 G3+74

This identifies the software

version number, software serial

Castle Care-Tech Ltd Euro-MERiDIAN Getting

Page 26 Software

number and product, and should

always be checked before

contacting Technical Support.

MODE SELECTION

The G3+ panel defaults to accept

‘End of Line’ wiring, but may be

programmed to use ‘iD’

technology by changing the

setting in the ‘Mode’ menu. The

G2-EoL endstation is EoL only and

G2-iD is iD only.

With display showing

CHANGE MODE?

Press YES

Detection Mode

EoL [ 1]

Use

D

to select between

iD [0] and EOL [1]

(

on Euro G3+ & above only)

Press YES

EOL Mode

DR [ 1]

Do

not

adjust this setting

unless single-resistor

wiring is to be used.

Press YES

Zone Response

400 mS [08]

Do

not

adjust this setting

Press YES

Zone XDF

Off [0]

DO NOT CHANGE THIS

SETTING, unless specifically

advised to do so by Castle

Care-Tech Ltd Technical

Support staff.

Press YES

CHOOSE MODE?

Press NO

Moves to next menu item

NOTES:

On systems with Zone Expander

Modules fitted, the zones will be

arranged as shown in the table on

page 27,28.

Zones wired from Keypads / Tag

Readers will ALWAYS be ‘End of

Line,’ regardless of mode selected.

ENABLE ZEMS

Before a ZEM can be used, it

must be correctly addressed (see

page 9) AND enabled in software

as follows:

With display showing

ENABLE ZEMs?

Press YES

ZEM Address

[ 0]

Select ZEM to be enabled,

eg press

1

and YES

ZEM Installed

No [0]

Use

D

to select

‘

Yes [1]

’

and press YES

ZEM Address

[ 1]

Repeat for additional

ZEMs or Press NO

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare