CASTLE EURO Spezifikationen PDF herunterladen (Seite 181)

Castle Care-Tech Ltd. Engineering

Page 23 - 6 Chapter 23

Initialisation and Test

Procedure

Before SMS messages can be

sent to a mobile ‘phone, it is

necessary to gain authorisation

for connection to the network,

and set up the call routing

through the appropriate

bureau.

This is done, after

programming the calls (as

described above), but before

programming 'content types'

by scrolling to ‘ENGINEER TESTS’

and following these steps:

ENGINEER TESTS

Press YES and then scroll

(with NO) to:

Test CHC

Communications?

Press YES

Testing to CHC

Please Wait

The panel communicates with the

Castle Host Computer (CHC),

which will initialise the system as

required.

When this is complete the display

will show EITHER

Test sent to CHC

Test Complete

The panel is now able to send SMS

Text messages.

OR

Failed to dial

CHC

The test call has failed.

Check:

Telecom Line is OK

Downloading is correctly set up

for

‘

MODEM

’

Digi/SMS Programmed correctly

Call = Active

Mobile number is programmed

correctly.

Press YES or NO to escape from

menu.

When testing, bear in mind

that a delay in receiving the

message is likely to be due to

the messaging service, rather

than the Control.

Communication Failure:

In the event of failure to

communicate with the CHC on

a routine test call, the panel

will display ‘CHC Test Fail’ until

the test is next conducted

successfully. This acts as a

reminder that SMS signalling

may not be operational, but

will NOT interfere with normal

system operation or SMS

signalling (if operative).

To permit sites with CHC

communication problems to be

traced, a record should be

maintained of the software serial

number of each site (see 13-4).

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 197 198

Kommentare zu diesen Handbüchern

Chrisaroks 29 Apr 2024 | 00:45:00

Hello, im noob :)